HP P5389A - Intel Pentium III-S 1.4 GHz Processor Upgrade Installation Manual page 15

Type "load a:\<directory>\<driver_name>", then the installation program will prompt
you to choose the slot number. At this point, NetWare will automatically the display
the valid slot numbers. Do not select a slot number by pressing the [Esc] key to avoid
loading the driver. Use <ALT><ESC> to toggle back to the installation screen and
enter the correct slot numbers displayed at the system console. Select Save
Parameters and Continue.
NOTE: Embedded Device Controllers slot number may be a 2 or greater digit number
(eg. 10, 103, 10003).
NOTE: If at the Disk Drive Parameters, you may have to enter the slot number by
selecting modify parameters.
NOTE: If the computer has dual onboard, embedded SCSI controllers then the driver
has to be added twice, the same for a dual SCSI card like the 3950.
16. Select Continue installation at the Drivers Summary screen to continue to
Network (LAN) Drivers.
17. Inspect the LAN drivers auto detected by Netware. Continue if no changes
are necessary. Otherwise make any changes if necessary.
a) To Delete LAN Drivers: Highlight the drivers that were auto-detected by
the NetWare installation program and press <Enter>. Under "Additional
driver actions" choose "Deselect a selected driver" and press <Enter>.
b) To Add LAN Drivers: Under "Additional driver actions" choose "Select an
additional driver" press <Enter>, then <insert> then <F3> to specify path.
Answer "NO" to any prompts to save any existing files.
18. Choose appropriate NIC driver or Press [F10] to continue and load from a driver
diskette. (Load from HP Driver Diskette when possible.) Continue on once all
appropriate NIC drivers have been chosen.
19. Wait while system loads drivers that were chosen
20. Inspect the Volume SYS and Partition Properties Screen. Select Modify if any
changes are necessary, and press the [F10] key to save any changes.
21. Select Continue after all changes have been applied.
22. Wait a few minutes while system files are copied and Netware GUI is started
23. Type in a Server Name at the Window prompt.
24. Select Free Space and click create. Type in a Volume name and select a Volume Type
for the first the partition. Click OK.
25. Choose YES, if necessary to mount all volumes when server reboots