Advertisement
DIP Switches
When using this interface board, the interface of the TM printer must be
selected as "parallel" with the appropriate settings. Set the reset signal for pin
31 to "enable," if you are using a TM printer that has this setting. Refer to the
manual for each TM printer for details.
How to Set Up the UB-R02
Preparation
Printing a Status Sheet
Power on the printer. Wait for a few seconds. Then, hold down the push
button on the interface card for more than 3 seconds. The printer prints the
parameters for the UB-R02. You can check all setting values necessary (SSID,
Network mode, IP address, Subnet mask, Gateway address) for the network
connection.
Connection
Set the setting of the host PC and AP to match the network setting that you
have confirmed with the status sheet.
You can check whether the connection to the printer has been correctly done
by inputting the ping command through the command prompt.
Example: Ping 192.168.192.168
Note:
Although the example shows the address 192.168.192.168, use whatever IP address is
reported on the status sheet.
Because the default IP addresses for all the wireless printers are the same, you should
power on and configure only one printer at a time.
Resetting the UB-R02 to Factory Defaults
Hold down the push button on the interface card while turning on printer
power and continue to hold it down for 5 seconds. This causes all internal
settings to return to their factory defaults.
2
Advertisement
