DigiTech Distortion Factory DF-7 Owner's Manual
  1. Manuals
  2. Brands
  3. DigiTech Manuals
  4. Music Pedal
  5. Distortion Factory DF-7
  6. Owner's manual

DigiTech Distortion Factory DF-7 Owner's Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Distortion Factory DF-7 and is the answer not in the manual?

Questions and answers

Related Manuals for DigiTech Distortion Factory DF-7

Summary of Contents for DigiTech Distortion Factory DF-7

  • Page 2 European Contact: Your local DigiTech Sales and Service apparatus has been exposed to rain or moisture, does Office or not operate normally, or has been dropped.
  • Page 3 DF-7’s cabinet models or amps in either stereo with 6 spectrum choices or mono. *DigiTech, DOD, Metal Master, Flexible Output Mode and CIT are trademarks of Harman International Industries, Incorporated. Other product names used in this document are trademarks of their respective companies and are not associated or affiliated with DigiTech.They are trademarks of other manufacturers...
  • Page 4 Factory Pedal • Input Impedance - 1 MOhms • Output Impedance - 100 Ohms • This Owner’s Manual • Power Supply - (Optional) DigiTech PS200R or 9V Alkaline Dry Battery • Battery Notice • Power Consumption - 4.8 Watts (w/optional PS200R power supply) •...
  • Page 5 Battery Replacement Battery Replacement Diagram Directions 1. Using the tip of a 1/4" guitar cable, push one of the release pins in on either side of the pedal, and remove the pedal from the pedal chassis. 2. Remove the battery from the battery compartment and disconnect the battery cable.
  • Page 6 Controls each MODEL’s low frequency boost or cut. 3. MID FREQ Adjusts each MODEL’s midrange center frequency.The range is from 200Hz to 5kHz. 4. MID Controls each MODEL’s midrange frequency boost or cut. 5. Power Supply Jack Connect only the DigiTech PS200R ®...
  • Page 7 Filter control. ™ 5. Based on the Boss® MT-2 Metal 7. GAIN Zone ® Controls each MODEL’s 6. Based on the DigiTech ® distortion/overdrive gain except for Metal Master the model based on the Big Muff ™ ®...
  • Page 8 following pages for more information 11. Pedal regarding each model and the Press the pedal to turn the effect Stereo Spectrum Set-up on and off. (See Flexible Output section for spectrum selection. Mode and Stereo Spectrum Set-up sections.) 9. INPUT Connect your instrument to this jack.
  • Page 9 14. OUT 2 (MIXER) overdrive sound. It is ideal for boosting This output has been specifically your signal without adding a lot of designed for use with a full range distortion. audio system. It is designed to be plugged directly into a mixer or For this model, the DF-7’s GAIN, recording device for optimal HIGH, and LEVEL knobs function...
  • Page 10 a Fender ‘65 Deluxe Reverb * 1x12 and HIGH controls giving you added ® ® cabinet. EQ flexibility so you can customize the model to your desired taste. DISTORTION MODEL 2 Set the DF-7’s LOW, MID, MID Based on the DOD FREQ, HIGH, and GAIN knobs to ®...
  • Page 11 signal while maintaining the dynamic DISTORTION MODEL 4 nuances of your playing. Based on the Pro Co Rat ™ For this model, the DF-7’s GAIN, This model was fashioned to recreate HIGH, and LEVEL knobs function the sonic boom of the Pro Co Rat* like the DS-1’s* Distortion,Tone, and pedal.
  • Page 12 Zone* pedal. It will add sustain and DISTORTION MODEL 6 Based on the DigiTech body to your sound while juicing up ® your mids and lows like a full stack. Metal Master ™ For this model, the DF-7’s LEVEL, This model is based on DigiTech’s...
  • Page 13 highly-acclaimed Metal Master pedal. fully clockwise to accurately reproduce We modeled the Metal Master with its this pedal model. Morph knob set to the minimum position.This model gives you a sweet When this model is selected, the CIT cabinet model used in Flexible singing solo tone with plenty of midrange to cut through any mix and Output Modes 1 and 2 is based on...
  • Page 14 Flexible Output Mode Tone controls, respectively. The DF-7 ™ also features separate LOW, MID, and MID FREQ controls giving you added The DF-7 not only sounds great EQ flexibility so you can customize the plugged into a single amp or mixer model to suit your taste.
  • Page 15 Connections The DF-7 Distortion Factory ™ equipped with a single INPUT and a highly powerful set of outputs that can be connected to both an amplifier OUT 1 (AMP) and a mixer OUT 2 (MIXER) simultaneously or configured so both OUTs can be connected to two mixer channels (Mode 2 stereo) or to two amps (Mode 3 stereo).
  • Page 16 Mode One: Single Amp and Single Mixer Out - Mono (default) (ONE FLASH) Power Supply (optional) Changes made to Flexible Output Mode and Stereo Spectrum are saved even after the DF-7 is turned off. Mode One does not utilize Stereo Spectrum.
  • Page 17 Mode One: Single Amp and Single Mixer Out - Mono (default) (ONE FLASH) Battery Power Use: Power Supply Use: 1. Press and hold the pedal switch. 1. Press and hold the pedal switch. 2. Insert a 1/4" guitar cable into the 2.
  • Page 18 Mode Two: Dual Mixer Out - Stereo (TWO FLASHES) Power Supply (optional) Both OUT 1 (AMP) and OUT 2 (MIXER) can be CIT enabled on each output ™ and configured for stereo use with two mixer/recorder channels.
  • Page 19 Mode Two: Dual Mixer Out - Stereo (TWO FLASHES) Battery Power Use: Power Supply Use: 1. Press and hold the pedal switch. 1. Press and hold the pedal switch. 2. Insert a 1/4" guitar cable into the 2. Connect the power supply to the input.The LED will light solid for power jack on the rear of the pedal approximately one second and then...
  • Page 20 Mode Three: Dual Amp Out - Stereo (THREE FLASHES) Power Supply (optional) Both OUT 1 (AMP) and OUT 2 (MIXER) can be configured for stereo use with two amplifiers...
  • Page 21 Mode Three: Dual Amp Out - Stereo - (THREE FLASHES) Battery Power Use: Power Supply Use: 1. Press and hold the pedal switch. 1. Press and hold the pedal switch. 2. Insert a 1/4" guitar cable into the 2. Connect the power supply to the input.The LED will light solid for power jack on the rear of the pedal approximately one second and then...
  • Page 22 Stereo Spectrum Selection Stereo Spectrum Set-Up: 1. Press and hold the Pedal Switch for In addition to having the two stereo 5 seconds.The Indicator LED will output modes (Mode 2 and Mode 3), flash twice if the DF-7 is in Mode 2, the DF-7 also has six different stereo or three times if the DF-7 is in spectrums to choose from when using...
  • Page 23 1.The warranty registration card must be mailed within ten days after purchase date to validate this warranty. 2. DigiTech warrants this product, when used solely within the U.S., to be free from defects in materials and workmanship under normal use and service.
  • Page 24 Harman International Industries Incorporated. *Other product names used in this document are trademarks of their respective companies and are not associated or affiliated with DigiTech.They are trademarks of other manufacturers and were used merely to identify products whose sounds...

Table of Contents

Save PDF