1 - 12 MC3000 User Guide
Latches
1
4
Battery with Pull Tab
Main Battery Removal (MC3090G)
Figure 1-11
NOTE The SD card holder is located under the battery. To install the SD card, see Secure Device Card on page 4-12.
Strap/Door Assembly Removal and Replacement (MC3000S/R)
The Strap/Door Assembly consists of a hand strap and the battery door. There are two versions of this assembly,
one for the Standard Battery and one for the Extended Life Battery. Before removing the Strap/Door Assembly,
press the red Power button to turn off the screen and set the mobile computer to suspend mode.
To remove the Strap/Door Assembly:
Rotate the latches to the open position.
1.
CAUTION
Do not lift up on the latches when removing the Strap/Door Assembly. Lift up on the Hand Strap only.
Lift the Hand Strap to lift the Strap/Door Assembly off, bottom first.
2.
Use a #00 Phillips screwdriver to remove the screws.
3.
Lift the mounting clip.
4.
Slide the mounting clip out of the strap loop.
5.
Reverse the procedure to replace the Strap/Door Assembly.
2
0.5 in.
(12.7 mm)
Battery Pull Tab
4
Battery without Pull Tab
Strap/Door
Assembly
3