Transmitter
Receiver
Servo
Battery holder
Others
Transmitter FP-T2NBL/T2NBR T2NBFR
Operating system
2 nick
Transmitting
27MHz, bands 1 to 6 72, 75MHz
frequency
Modulation
AM (Amplitude Modulation)
12.0V, penlight battery x 8
Power requirement
Current drain
170mA
TRANSMITTER FP-T2NBL/T2NBR/T2NBFR
• Nomenclature
•The name of each part of the transmitter is
shown in the figure. Learn them before ope-
rating your set.
When running the vehicle, extend the antenna
fully.
Frequency flag
Neutral lever
Throttle trim
Throttle stick
ASP setting
ASP setting
trimmer
switch
(NEW ATTACK-BFR only)
Servo reverse switches
(NEW ATTACK-R, NEW ATTACK-BFR)
CONTENTS AND RATINGS
FP-T2NBL x 1
FP-R102GFx 1
FP-S128x2
R2-BSS-N x 1
Switch, frequency flag, spare horn
Receiving
frequency
Intermediate
frequency
Selectivity
Receiving range
Power supply
Dimensions
Weight
Antenna
FP-T2NBR x 1
FP-R102GF x 1
FP-S128x2
R2-BSS-N x 1
Ratings are subject to change without prior notice.
Receiver FP-R102GF
27MHz band. bands 1 to 6
72. 75MHz
455kHz
3kHz/-3dB
550 yards (500m) on the ground
when used with FP T2NBLIA1 the
best radio wave condition of
environment)
4.8V to 8 4V
7.2V/13mA. 4 8V/33mA
1.46 x 2 . 1 9 x 0 . 7 5 in
(37 x 55.5 x 19mm)
1.34 oz 138g)
BEC & ASP functions
Before using the set, check the remaining
battery capacity by checking the level meter.
Good
2
FP-T2NBFR x 1
FP-R102GF x 1
FP-S128x 2
R2BSS-N x 1
SERVO FP-S128
Control system
pulse width control
Operating angle
One side 45° or more
Power
4.8V -6
requirement
Current drain
6.0V. 8mA (at Idle)
(IDLE)
Output torque
48.7 oz.in. 13.5 kg-cm)
Operating speed
0.24 sec/60
Dimensions
1 6 x 0 8 x 1.6 in.
(40.5 x 20 x 40.5mm)
1.92oz. 153g)
Weight
Caution
No good
Change the battery.
Level meter
Steering stick
Steering trim
Power switch
Transmitter
crystal holder
Handle
Hook
Need help?
Do you have a question about the ATTACK and is the answer not in the manual?
Questions and answers