Cisco ATA188-I2 Configuration page 16

Refer to the appropriate illustration and follow these steps to
install your ATA:
Procedure
Place the Cisco ATA near an electrical power outlet.
Step 1
Connect one end of a telephone line cord to the Phone
Step 2
1 input on the rear panel of the Cisco ATA. Connect the
other end to an analog telephone set.
If you are connecting a telephone set that was
previously connected to an active telephone line,
unplug the telephone line cord from the wall jack and
plug it into the Phone 1 input.
Warning To reduce the risk of fire, use only No. 26 AWG or
larger telecommunication line cord.
16