Installing Your Removable Drive in an HP SureStore H/A Tape Array 5500
Step 1: Attach Local Language Labels if Necessary
Step 2: Install the Tape Drive
1 Ensure that the extractor lever on the drive is in the out position, as shown
2 Lift the drive carefully and turn it so that it is on its side with the extractor
3 Align the rear of the drive with the guides on the bottom of the
extractor lever
4 Slide the drive along the guides until the connectors on the back mate with
1
Figure 1.1 HP SureStore H/A Tape Array 5500 showing five drives installed.
NOTE
A set of labels for the front panel in several different languages is provided
with the drive. Identify those with your local language, peel them from the
backing paper and stick them firmly to the front panel of the drive over the
English-language labels.
in the picture.
lever at the bottom.
HP SureStore H/A Tape Array 5500.
the connectors at the back of the enclosure.
P
ush the extractor lever in until it locks the drive in position.
• SCSI IDs for drives in the tape array are set on the back panel of the
array.
• If you are installing fewer than five drives in the tape array, you need to
use a blanking plate.
See the documentation with the tape array for details.
Step 1: Attach Local Language Labels if Necessary
1-3