Festive T2114 Series Instructions

P051454- 90cm shimmer fibre optic tree with tree top star
P051455- 120cm shimmer fibre optic tree with tree top star
P051456- 150cm shimmer fibre optic tree with tree top star
P051457- 180cm shimmer fibre optic tree with tree top star
These instructions are for your safety. Please read them thoroughly before use and retain for future reference. Please see the
additional information on cable label.
Before You Start - No tools required for assembly.
•
Make sure that you have plenty of space and a clean dry place for assembly.
•
Always try to assemble the product as close as possible to the intended location.
•
Remove all plastic bags and dispose of safely.
Positioning Instructions
1) This Fibre Optic Tree is for INDOOR USE ONLY.
2) Do not position or place near heaters or any other direct sources of heat.
3) Always position cables and extension leads so that they will not be a hazard to the elderly, pets, and children.
4) DO NOT position this product where it may be covered by other items e.g. curtains, nets or bedding or tree skirts.
5) The mains transformer MUST be located INDOORS.
6) This product is suitable for positioning on surfaces which have normal flammability e.g. wood, plasterboard, and
masonry. However, this does not include highly flammable surfaces (e.g. polystyrene, textiles).
7) Place tree on a level surface. Do not place on long pile carpet, as this may affect stability and interfere with the ventilation
of the base. Do not cover the ventilation holes in the base.
8) This product is not designed for permanent or long-term use.
Assembly
Assembly for trees with POT
fig.1 fig.2
Prepare the base. fig.1 ready
Insert tree into the hole of the base as fig. 2
Connect the output cable from the foot of the tree to the
transformer, using the power cable provided as fig.3.
Shape tree by arranging branches to create a full and
natural look.
Connect the transformer into mains supply & switch on at
the wall socket.
The tree will light up; the colour will change and shimmer.
Assembly for stand.
fig.3
Unfold the metal base, install the screws as fig.1.
Insert tree trunk into the hole of the base, tighten the screws
to fix the tree.
Connect the output cable from the foot of the tree to the
transformer, using the power cable provided as fig.2.
Shape tree by arranging branches to create a full and natural
look.
Connect the transformer into mains supply.
The tree will light up; the colour will change and shimmer.
TYPE
T2114
QSF1001