Pulsar 510DL Centro Instruction Manual

SPECS
Size: 3.45" x 1.67" x 0.78" (87.7mm x 42.4mm x 19.8mm)
Max Cart Size: .55" x 2.28" (14mm x 58mm)
Battery Capacity: 650mAh
Voltage: 1.8v / 2.4v / 2.8v / 3.4v / 3.8v (1.8v Pre-heat)
Charging: USB-C
Resistance: ≥0.8
KIT INCLUDES
1x Pulsar DL Centro Battery
1x Bottom Magnetic Connecter
POWER ON/OFF
Press the power button quickly 5 times to turn the device on or off.
PRE HEATING
Quickly pull from the mouthpiece twice to activate the pre-heat function. You can also press the power button on
the side 2 times to activate the pre-heat function.
CHANGE VOLTAGE SETTINGS
You change the setting by pressing the power button 1 time. The screen also indicates the voltage setting.
1.8v - Yellow
2.4v - Purple
2.8v - Green
3.4v - Blue
3.8v - Red
CHARGING
The LED light will be red while charging and the lightning icon will flash on screen. When the device is fully charged
the LED will change to green and the lightning icon will stop flashing. When the battery is dead the LED will flash red
10 times and enter standby mode to let you know it needs to be charged before it's used again.
PROTECTION FEATURES
Battery life/ cartridge protection: After 10 continuous seconds of use, the red light will flash 4 times and enter
standby mode.
Over-voltage/short-circuit protection: The LED will flash red 3 times and the device will fully turn off.
If there is no cartridge or dead cartridge: The LED will flash white 3 times.
INSTRUCTIONS
1. Make sure the bottom magnetic connector is properly connected to the battery. The battery will not charge if
the bottom connector is not attached.
2. Before using the DL Centro, fully charge the device using a USB-C charging cable and a standard charging
brick. You will see the LED and screen turn on and the light band will be red when the battery is charging.
3. Allow the battery to fully charge before the first use. When the LED light turns green and the screen shows
100% the device is fully charged and can be unplugged.
4. Remove the bottom magnetic connector and firmly screw in the 510-threaded cartridge of your choice.
5. Insert the cartridge into the device and ensure the bottom magnetic connector is properly connected. The
LED will flash green to let you know there is a good connection.
6. Press the power button 1 time to adjust the voltage.
PAGE 1
INSTRUCTION
MANUAL
PulsarShop.com
PU-0759-24