Dell Dimension 2100 Solution Manual page 79

To insert a module, press out the securing clip at each end of the
6
memory connector.
securing clips (2)
notches (2)
memory module
connector
cutouts (2)
step 6
step 7
Align the notches on the bottom of the module with the crossbars in
7
the connector.
NOTICE:
To avoid breaking the memory module, do not press near the middle
of the module.
Insert the module straight down into the connector, making sure that
8
it fits into the vertical guides at each end of the connector.
Press firmly on the ends of the module until it snaps into place.
If you insert the module correctly, the securing clips snap into the
cutouts at each end of the module.
system board
location
step 8
0 1
1
2
3
4
Adding Pa rts 79