HP dx2358 - Microtower PC Hardware Reference Manual page 32

✎
✎
Hardware Reference Guide
5. Attach the two screws that secure the hard disk drive cage to the
chassis.
Securing the Hard Drive Cage
6. If installing a new drive, connect the opposite end of the data
cable to the appropriate system board connector.
If your system has only one SATA hard drive, you must connect the
hard drive data cable to the dark blue connector labeled SATA0 to
avoid any hard drive performance problems. If you are adding a
second hard drive, connect the data cable to the next available
(unpopulated) SATA connector on the system board in the following
order: SATA0, SATA1, SATA3, SATA2.
7. Replace the computer access panel.
8. Reconnect the power cord and any external devices, then turn on
the computer.
9. Lock any security devices that were disengaged when the access
panel was removed.
If you are replacing the primary hard drive, use the Recovery Disc Set
to restore the operating system, software drivers, and any software
applications that were preinstalled on the computer.
www.hp.com
Hardware Upgrades
2–22