Advertisement
Quick Links
Advertisement
Related Manuals for HORAGE AUTARK TOURBILLON
Summary of Contents for HORAGE AUTARK TOURBILLON
- Page 1 A U T A R K T O U R B I L L O N U S E R M A N U A L...
- Page 2 Dear Customer, Congratulations on your new HORAGE Autark Tourbillon, we hope it brings you much joy in the years to come. Please be sure to review the “Important Information” and “Operation Instructions” listed below prior to using your Autark Tourbillon.
- Page 3 • The Autark Tourbillon has a power reserve of over 3 days or circa 72 hours. A fully wound watch may run a little longer than 3 days if not worn, however, the amplitude or consistency of the...
- Page 4 K - T M R M I C R O R O T O R T O U R B I L L O N USEFUL INFORMATION • The accuracy of the Autark Tourbillon is calculated within a 3-day operating timeframe and therefore to ensure your watch remains precise please be sure to wear or manually wind the watch on, or before, the 3rd day prior to it last being worn or wound.
- Page 5 AUTARK TOURBILLON K - T M R M I C R O R O T O R T O U R B I L L O N USEFUL INFORMATION • Excessive, continued turning of the crown can reduce the longevity of seals used for water resistance.
- Page 6 AUTARK TOURBILLON K - T M R M I C R O R O T O R T O U R B I L L O N OVERVIEW Power Reserve Indicator Minute Hand Adjustment Crown Hour Hand Blued Seconds Indicator * A Power Reserve Indicator is fitted to the Gradient Gray and optionally on the Salmon Dial.
- Page 7 AUTARK TOURBILLON K - T M R M I C R O R O T O R T O U R B I L L O N...
- Page 8 AUTARK TOURBILLON K - T M R M I C R O R O T O R T O U R B I L L O N Position 0: Crown in Pushed Home Position • The crown is completely against the case and a properly maintained watch will be water resistant to the depth noted on the case back when the crown is in this position.
- Page 9 AUTARK TOURBILLON K - T M R M I C R O R O T O R T O U R B I L L O N Position 0: Winding Position • In this position, you can wind the watch manually by turning the crown clockwise.
- Page 10 AUTARK TOURBILLON K - T M R M I C R O R O T O R T O U R B I L L O N Position 1: Setting The Time • With the crown pulled outwards to the first notch also referred to as Position 1 turn the crown clockwise to set the Hour and Minute Hands correctly.
- Page 11 Horage Micro Adjust Clasp (HMAC) • The clasp fitted to the metal bracelet is equipped with the Horage Micro Adjust Clasp (HMAC). This clasp allows for 10mm of length adjustment in 1mm steps. • To adjust the clasp to the longest (extended) position the bracelet clasp must be in the open position.
- Page 12 AUTARK TOURBILLON K - T M R M I C R O R O T O R T O U R B I L L O N...
- Page 13 HORAGE SA Factory 1 Solothurnstrasse 1, 2504 Biel, Switzerland www.horage.com...
Need help?
Do you have a question about the AUTARK TOURBILLON and is the answer not in the manual?
Questions and answers