Dell POWEREDGE EMU01 Hardware Owner's Manual page 27

Table 1-8. System Messages (continued)
Message
No boot sector on hard
drive
No timer tick interrupt
Not a boot diskette
PCIe Degraded Link Width
Error: Embedded
Bus# nn /Dev# nn /Func n
Expected Link Width is n
Actual Link Width is n
PCIe Degraded Link Width
Error: Slot n
Expected Link Width is n
Actual Link Width is n
PCIe Fatal Error caused a
system reset: Slot n
or
Embedded
Bus# nn /Dev# nn /Func n
Please check the system
event log for details.
PCI BIOS failed to install PCI device BIOS (Option ROM)
Plug & Play Configuration
Error
Causes
Incorrect configuration settings in
System Setup program, or no
operating system on hard drive.
Faulty system board.
No operating system on diskette.
Faulty or improperly installed PCIe
card in the specified slot.
Faulty or improperly installed PCIe
card in the specified slot.
Faulty or improperly installed PCIe
card in the specified slot.
checksum failure is detected during
shadowing. Loose cables to expansion
card(s); faulty or improperly installed
expansion card.
Error encountered in initializing PCI
device; faulty system board.
Corrective Actions
Check the hard-drive configuration
settings in the System Setup program.
See "Using the System Setup Program"
on page 31. If necessary, install the
operating system on your hard drive. See
your operating system documentation.
See "Getting Help" on page 129.
Use a bootable diskette.
Reseat the PCIe card in the specified
slot number. See "Installing an
Expansion Card" on page 53. If the
problem persists, see "Getting Help" on
page 129.
Reseat the PCIe card in the specified
slot number. See "Installing an
Expansion Card" on page 53. If the
problem persists, see "Getting Help" on
page 129.
Reseat the PCIe card in the specified
slot number. See "Installing an
Expansion Card" on page 53. If the
problem persists, see "Getting Help" on
page 129.
Reseat the expansion cards. Ensure that
all appropriate cables are securely
connected to the expansion cards. If the
problem persists, see "Troubleshooting
Expansion Cards" on page 113.
Install the NVRAM_CLR jumper and
reboot the system. See Figure 6-1 for
jumper locations. If the problem persists,
see "Troubleshooting Expansion Cards"
on page 113.
About Your System
27