Removing And Installing Fuel Hoses; Removing And Installing Feed And Return Lines - BMW F 650 GS Repair Manual

Removing and installing fuel hoses

d
Warning:
Comply with safety precautions when handling or
working with fuel; note that the fuel lines are pressu-
rised.
Removing and installing feed and
return lines
– Remove seat.
– Remove left cover.
•
Remove the BMS control unit from the holder.
•
Disengage the oil tank.
3
2
•
Remove the fastener securing the fuel filter (1) to
the frame bow.
•
Slacken hose clamps.
d
Warning:
Fuel escapes when the hoses are disconnected.
•
Disconnect fuel feed line (2) and fuel return
line (3).
•
Installation is the reverse of the removal proce-
dure: pay particular attention to the following.
e
Caution:
Note the installed positions of fuel feed line (2) and
fuel return line (3).
•
Secure hose clips (2, 3) with pliers,
BMW No. 13 1 500.
13.10
1
E130101
Removing and installing line to
13 31 135
fuel injector
– Remove seat.
– Remove left, right and centre covers.
•
Use a hose clamp, BMW No. 13 3 010, to close
off the fuel feed line.
•
Open hose clips (4, 5).
•
Disconnect the fuel line.
•
Installation is the reverse of the removal proce-
dure: pay particular attention to the following.
•
Secure hose clip (5) with pliers,
BMW No. 13 1 500.
Removing and installing
32 72 305
throttle cable
See Group 32
4
5
E130120