Mercedes-Benz Vito 2014 Operating Instructions Manual page 265

On-board computer (vehicles without steering wheel buttons)
262
Use the buttons in the instrument cluster.
Press È to select the ? coolant tem-
X
perature bar display.
Under normal operating conditions and with
the specified coolant level, the coolant tem-
perature display:
may rise to 110 † on vehicles with an
R
engine output of under 100 kW
may rise to 120 † on vehicles with an
R
engine output above 100 kW
Settings menu
Introduction
Settings menu start screen
The vehicle must be stationary. Use the but-
tons in the instrument cluster.
To display: press Èto select the
X
tings tings menu.
The Settings Settings
the vehicle is stationary. You can think of the
order of the submenus and functions as a cir-
cle. Press 3 on the instrument cluster to
scroll through the menu, starting with its start
screen and select its submenus or functions
successively.
If you scroll forward using 3, the setting from
the previous submenu or function is adopted.
If you press È in a submenu, the submenu or
function is exited without adopting the set-
ting. The display then shows the start screen
of the Settings Settings
Depending on the vehicle's equipment, you
have the following options in the
menu:
menu is only displayed when
menu.
Settings Settings
Setting the language for the display mes-
R
sages and displays (
Deactivating and activating ESP
R
( page 262)
Y
Setting the sensitivity of the rain sensor
R
( page 263)
Y
Activating and deactivating ATTENTION
R
ASSIST (
Activating and deactivating Intelligent Light
R
System (
Setting permanent SPEEDTRONIC
R
( page 264)
Y
Selecting the permanent display in the dis-
R
play's header (not for United Kingdom)
( page 264)
Y
Setting the unit for distance, consumption
R
and speed displays (
Setting the time and date (
R
To reset settings to the factory settings:
X
turn the key to position 1 in the ignition lock
and press 3 in the
least 5 seconds.
For safety reasons, not all functions are reset.
The limit speed for permanent SPEEDTRONIC
can only be adjusted in the
Set‐ Set‐
submenu.
Setting the display language
The vehicle must be stationary. Use the but-
tons in the instrument cluster.
Press È to select the
X
Press 3 to select the
X
The display shows the current language
selection.
Press f or g to set the language for all
X
display messages.
Press 3 to confirm.
X
The next submenu is shown in the display.
Deactivating/activating ESP
This menu is only available on vehicles with-
out the å button on the centre console.
page 262)
Y
page 263)
Y
page 264)
Y
page 264)
Y
page 265)
Y
Settings Settings
Winter tyres Winter tyres
Settings Settings
Language Language
®
menu for at
menu.
submenu.
®