TracVision A7 Installation Manual page 35

TracVision A7 Installation Guide
6. Set aside the backing plate, then use a
to drill the three fitting mounting holes.
Cable Access Hole and Fitting Mounting Holes
1 ⁄ " Cable
2
Access Hole
7. Insert the antenna cable into the access hole.
Inside the vehicle, pass the cable through the
backing plate and route the cable to the receiver.
Cable Routed Into Vehicle Through Access Hole
2.18
5 ⁄ " drill bit
3 2
5 ⁄ " Fitting
3 2
Mounting Hole
Cable Fitting
8. Move the fitting down the cable until it covers the
cable access hole, flush to the vehicle's roof. Line
up the fitting's three mounting holes with the
three 5 ⁄ " holes drilled in the roof. Apply silicone
3 2
sealant or RTV to the holes and insert the #6-32 x
5 ⁄ " screws supplied in the kitpack.
8
Fitting Mounted to Roof
Clamping Nut
Cable Fitting
54-0350