Advertisement
Features
The NEC VersaBay IV 6-cell secondary battery can be installed in the VersaBay IV slot, for use
in addition to the primary battery. See the following figure for features.
Removing a Device from the NEC VersaBay IV Slot
Before installing your new NEC VersaBay IV drive, remove any device or the weight-saving
module (if in place) from the VersaBay IV slot as follows.
If a VersaBay IV drive is in the slot, use the Phoenix
1.
system. (See your printed user's guide for information about the Phoenix BaySwap utility.)
If a VersaBay IV weight-saving module is in the VersaBay IV slot, skip to step 2.
Locate the NEC VersaBay IV release latch to the right of the VersaBay IV slot.
2.
Flip the latch to the open position. Then press the latch into the system to eject the device.
3.
Pull the device out of the system.
4.
2 NEC VersaBay IV 6-Cell Secondary Battery
The VersaBay IV secondary battery
A – Battery Connector
Removing a device from the VersaBay IV slot
B – Notch for Latch/Eject Lever
®
BaySwap™ utility or power off the
Advertisement
