NEC VERSA MINIDOCK 6000 Manual page 8

T
Eject Lever — The Eject lever disconnects the NEC Versa from the
MiniDock docking connector. Before pressing the Eject lever, you must
prepare your system for undocking by pressing the undocking button or
the power button on the side of the MiniDock. (See Chapter 2, "Docking
and Undocking," for details about undocking procedures.)
T
Air Vents — These vents allow the MiniDock to cool properly. Keep the
vents free of paper and debris to allow for proper air circulation.
T
Docking Connector — This connector fits the expansion port on your
NEC Versa to allow for docking.
T
AC Port Guard — The adjustable AC port guard keeps you from acci-
dentally docking the NEC Versa while it is still plugged into the AC
adapter. When the notebook is docked, the MiniDock supplies power to
run the system and charges the battery installed in the NEC Versa.
T
Notebook Glide — This panel allows your notebook computer to glide
easily towards the docking connector during docking and away from the
connector while undocking.
T
Docking Grips — The docking grips give you the leverage you need to
connect the expansion port on the notebook computer to the docking con-
nector on the MiniDock.
T
Docking LEDs — These LEDs inform you of the current docking status,
IDE drive access, and diskette drive access. LEDs are shown in the fol-
lowing figure and LED states are described after the figure.
MiniDock LEDs
Introducing the NEC MiniDock 6000 1-3