NEC VERSA FX Manual page 51

— Off — disables power management and all device timeouts. Works well in an
— Custom — lets you define power management levels and specific device
LCD Suspend — Allows you to Suspend/Resume when the LCD panel is closed.
!
(Not applicable in Windows 98 with ACPI.)
Suspend Option — Specifies either Suspend or Save to File (STF) when the LCD
!
Suspend parameter is enabled. For more details about using this parameter in
Windows 98, see the section, "Managing System Power," later in this chapter.
Automatic STF — Enables the system, after 30 minutes in Suspend mode, to save
!
the current working environment to a special file on the hard disk and to power
down the system. For more details about using this parameter in Windows 98, see
the section, "Managing System Power," later in this chapter.
Panel Brightness — Selects the LCD screen brightness.
!
Suspend Warning Tone — Specifies whether the system warning tone sounds when
!
Suspend mode starts. It is best to keep this option enabled. (Not applicable in
Windows 98 with ACPI.)
Remote Power On — Allows the serial port modem or LAN board to wake the
!
system on a ring signal.
3-12 Using the BIOS Setup Utility
office environment while powering your NEC Versa with AC power.
timeouts according to your own needs and present environment. Custom lets
you set the following timeouts.
Option
CPU Speed Control
Hard Disk Timeout
Video Timeout
Peripheral Timeout
Audio Device
Timeout
Standby Timeout
Auto Suspend
Timeout
Custom Timeout Options
Definition
Sets CPU performance at one of four levels.
Sets the time delay before your hard disk powers
down.
Sets the time delay before your video powers off.
Sets the time delay before your peripherals are
controlled by power management.
Sets the time delay before your audio device powers
off.
Selects the system standby timeout period.
Defines how much time elapses from the time the
system enters Standby mode to the time the system
automatically enters Suspend mode.