Startup Menu - NEC VERSA 2600 Service Manual

Parameter
Miscellaneous
Low battery beep
Wake Up Alarm
Hour
Minute
L2 Cache
Exit
Save and Exit
Save and Reboot
Exit (No Save)
Default Settings
Version Info
As a new user, it is important to check and perhaps change the following parameter set-
tings.

Startup Menu

T
Date and Time
Set the System Date and Time to the current date and time. Use numerical input
(remember that the hour setting begins at 0 and ends at 23). The settings remain in
memory even after you turn off system power.
T
Boot Device
Select the drive you want your system to read from when the computer starts up.
Specify the boot sequence, by instructing the system to look
only to the Hard Disk, drive C
first to the Diskette, drive A, and then to drive C.
Table 2-6 Setup Parameters
Default
Setting
Enabled
(checked)
Disabled
Enabled
(checked)
To save the
current setup
parameters (with
changes) and exit
setup.
Displays
information about
Setup and BIOS.
Setup and Operation
Alternate
Settings
Disabled (unchecked)
One Time, Every Day
User input
User input
Disabled (unchecked)
To save the current
setup parameters, then
reboot the computer.
To exit Setup without
saving any parameter
setting changes.
To restore the default
Setup settings, then
Exit.
2-21