NEC MOBILE TERMINAL EX User Manual page 22

Charging the BATTERY PACK by Single Docking Station EX
The following describes the procedure and notes on charging the BATTERY PACK installed in
Mobile Terminal EX by Single Docking Station EX.
1.
Connect the DC plug to the AC adapter connector.
2.
Connect the power cable to the inlet of the AC adapter.
3.
Insert the power plug of the power cable to an outlet.
4.
If you set the power switch to ON, then the power lamp on Single Docking Station EX goes
on.
5.
Insert Mobile Terminal EX to Single Docking Station EX.
6.
The connecting detection lamp goes on to indicate that Mobile Terminal EX is connected to
Single Docking Station EX securely.
7.
Charging is started.
The charge lamp on Mobile Terminal EX allows you to know the charge status.
If the connecting detection lamp does not go on, check if Mobile Terminal EX is inserted to
Single Docking Station EX properly.
Before Mobile Terminal EX can be inserted to Single Docking Station EX, the AC adapter
must be disconnected from Mobile Terminal EX if connected.
Mobile Terminal EX is available if it is charged.
Mobile Terminal EX can be charged in the ambient temperature range between 5ºC and
35ºC. However, to enable the battery to bring out its performance sufficiently, it is
recommended to charge Mobile Terminal EX in the ambient temperature range between
18ºC and 28ºC.
Other Notes
To turn on the power again after power-off, press the power switch after five seconds or
longer has passed from the power-off.
If Mobile Terminal EX is removed from Single Docking Station EX and then inserted again,
wait for five seconds or longer from the removal to the insertion.
- 21 -