Isotherm Freeline Slim 70 Installation And Usage Instructions page 71

ATTENTION
The product is suitable for installation in recreational vehicles only.
Not suitable for boats.
4.1 Inspections and packaging removal
After removing the packaging, check all the parts for any transport damage.
In the event of a dispute, contact the supplier where the product was purchased or our customer
support service.
IMPORTANT
The product and accessories are wrapped with buffer materials or attached with
adhesive tape to prevent movement of movable parts during transport: remove them
all before installation. Always transport the product in the upright position.
IMPORTANT
The packaging protected the product from transport damage. All materials used are
compatible with the environment and recyclable. Please contribute: dispose of the
packaging according to environmental standards. Request information on current
disposal methods from your specialized dealer or your local administration.
4.2 Positioning
The product was designed and created for recessed installation and conforms to standard
dimensions. The product must always be kept in a vertical position, with the rubber feet on
the compressor on the bottom. The compressor can operate at an inclination of up to 30°. At a
greater inclination, the compressor may become damaged.
1) Install the product in a stable cabinet, respecting the ventilation spaces shown in the figure;
2) Place the product partially in the cabinet, leaving 10 cm of space at the top (see detail A);
3) Connect the power supply connector to the 12 or 24 V outlet on the vehicle;
4) Slide the product into the cabinet.
The operations indicated in this section must be performed by a
qualified installer. To avoid cutting risks, always use appropriate PPE
(personal protective equipment).
The operations indicated in this section must be performed by a
qualified installer. To avoid cutting risks, always use appropriate PPE
(personal protective equipment).
Installation
71