Yamaha RX5 Owner's Manual page 54

CARTRIDGE MODE
3. To verify the data, press +1/YES again.
CARTRIDGE CTRL
Verify executing
If the data has been correctly saved, the LCD will then show
CARTRIDGE CTRL
Verify ОК!!!
If any other messages appear, refer to the ERROR MESSAGES chapter.
JOB #23: VERIFY SINGLE PATTERN.
FUNCTION то verify that the data of a single selected Pattern has been
correctly saved onto Yamaha RAM4 Data Cartridge.
This operation actually allows you to compare any of the 100 Patterns stored in the RX5
with any of the 100 Patterns saved onto cartridge. The two Pattern numbers you will
enter may be different, if you have saved a Pattern to a differently-numbered destination
in the RAMA cartridge.
OPERATION This Job corresponds to (and should be carried out
subsequent to) Job #03, Save Single Pattern.
1. After saving a Pattern, press CASSETTE/CARTRIDGE once or twice to enter the
Cartridge Mode, then select Job #23.
CARTRIDGE CTRL
Verify РТМ 88 ?
2. To continue the Verify operation, press +1/YES.
CARTRIDGE CTRL
РТМ 905» Crt жж
3. Use the Numeric Key Pad to select the number of the Pattern stored in the RX5.
Example: 11.
CARTRIDGE CTRL
РТМ 1182 Crt жж
Prompt to enter Cartridge Pattern number
4. Press ACCENT 2 to move the cursor to the right, and use the Numeric Key Pad to
select the number of the Pattern saved on the cartridge. Example: 22.
CARTRIDGE CTRL _
РТМ 11 > Crt 220
You can use the АССЕМТ 2 key to move the cursor back and forwards to allow you to
reset the RX5 Pattern and cartridge Pattern numbers.
5. Once the cursor is on the right of the LCD, Press +1/YES to continue the Verify
operation
CARTRIDGE CTRL
Verify sure ?
You now һауе a chance to cancel the Verify operation by pressing —1/МО.
6. To verify the data, press +1/YES again.
If the data has been correctly saved, the LCD will then show
CARTRIDGE CTRL
Verify ОК!!!
If any other messages appear, refer to the ERROR MESSAGES chapter.