Table Of Contents; Installation; Preparation - VDO CD 5104 Manual

BEFORE YOU START....
Thank you for purchasing our product which has been designed and manufactured to the highest
standards and subjected to rigorous testing.
Kindly familiarise yourself with the product by reading this user manual. Keep this manual handy in
your car for future reference.
This manual covers the following models: CD5104, CD5204, CD5304 MP3, CD5404 MP3 X
The main differences as the below chart:
Power
CD5104 4 x 35 W
CD5204 4 x 35 W
CD5304 MP3 4 x 35 W
CD5404 MP3 X 4 x 45 W
ENVIRONMENT
This booklet is printed on low-chlorine recyclable
paper.
IMPORTANT
This device has been designed and produced
according to applicable Safety Regulations.
Please read carefully the instruction manual and
use the device as intended.
CONTENTS PAGE
INSTALLATION ................................................ 4
PREPARATION ................................................ 4
MOUNTING ..................................................... 6
FRONT PANEL PRESENTATION ................... 7
SECURITY ....................................................... 8
AUDIO .............................................................. 8
RADIO .............................................................. 9
RADIO DATA SYSTEM (RDS) ON FM ........... 9
CD/MP3*/CD CHANGER* PLAYER .............. 10
SPECIAL FUNCTIONS .................................. 11
SETUP ............................................................ 12
TROUBLE SHOOTING ................................. 14
* Depending on version
4
MP3 2 Channel
Playback Pre-out
---- ----
---- ----
----

INSTALLATION

If your car is equipped with ISO connectors,
simply insert them in the connectors of the car
radio. If not, you can use an adaptor cable. Ensure
all cables are installed so that they cannot be
damaged by sharp edges or moving parts.

PREPARATION

Voltag e and polarity: The set must be
connected to a 12V car battery with negative
terminal to earth (car chassis). Installation in
vehicles not fulfilling these requirements could
result in malfunction, damage or fire.
connected (fig.1 See separate installation card).
CONNECTOR A (fig.2)
Power supply connections
• A7 : Connect to a permanent 12V supply.
This is the main power supply. Ensure this
connection can handle a current of 10A.
• A4 : Connect to a switched 12Vsupply
(switched on/off by car ignition).
• A8: Connect to earth (car chassis).
This connection set up will enable you to make
full use of the ON/OFF LOGIC function of this set
limiting the use of the set to 1 hour after removal
of the ignition key. If this feature does not appear
to be functioning as expected you may require
an adaptor cable.
4
CD Changer Hand Free
Control or Auxiliary Phone in
---- ----
---- ----
---- ----
Warning: To prevent shor t-circuiting,
disconnect the negative car battery terminal
until the set has been mounted and
2004-12-2, 9:06
Switchable
Illumination
----
----