AEG NBB8S621AB User Manual page 9

5. BEFORE FIRST USE
WARNING!
Refer to Safety chapters.
5.1 First connection
The display shows welcome message after
the first connection.
You have to set: Language, Display
Brightness, Key Tones, Buzzer Volume,
Water Hardness, Time of Day.
5.2 Wireless connection
To connect the appliance you need:
• Wireless network with the Internet
connection.
• Mobile device connected to the same
wireless network.
1. To download the app scan the QR code
located on the back cover of the user
manual. You can also download the app
directly from the app store.
2. Follow the app onboarding instructions.
3. Turn on the appliance.
4. Press . Select: Settings / Connections.
5. - slide or press to turn on or off: Wi-Fi.
The appliance wireless module starts within
90 sec.
For safety reasons, remote operation
turns off automatically after 24 h. Repeat
the onboarding, if needed.
Frequency 2.4 GHz WLAN
2400 - 2483.5 MHz
Protocol IEEE 802.11b DSSS, 802.11g/n
OFDM
Max Power EIRP < 20 dBm (100 mW )
Wi-Fi module NIUS-50
5.3 Software licences
The software in this product contains
components that are based on free and open
source software. AEG acknowledges the
contributions of the open software and
robotics communities to the development
project.
To access the source code of these free and
open source software components whose
license conditions require publishing, and to
see their full copyright information and
applicable license terms, visit: http://
aeg.opensoftwarerepository.com (folder
NIUS).
5.4 Initial preheating and cleaning
Preheat the empty appliance before the first
use and contact with food. The appliance can
emit unpleasant smell and smoke. Ventilate
the room during preheating.
1. Remove all accessories and removable
shelf supports from the appliance.
2. Set the function
temperature. Let the appliance operate
for 1 h.
3. Set the function
temperature. Let the appliance operate
for 15 min.
4. Set the function
temperature. Let the appliance operate
for 15 min.
5. Turn off the appliance and wait until it is
cold.
6. Clean the appliance and the accessories
only with a microfibre cloth, warm water
and a mild detergent.
7. Put the accessories and removable shelf
supports back to their initial position.
5.5 Setting: Water Hardness
When you connect the appliance to the mains
you have to set the water hardness level.
Use the test paper or contact your water
supplier to check the water hardness level.
1. Put the test paper into the tap water for
about 1 sec. Do not put the test paper
under running water.
2. Shake the test paper to remove any
remaining water.
. Set the maximum
. Set the maximum
. Set the maximum
ENGLISH 9