Configuring Ftp; Ftp Commands - ZyXEL Communications ZYWALL USG CLI Reference Manual

34.6.1 Telnet Commands Examples
This command sets a service control rule that allowed the computers with the IP addresses
matching the specified address object to access the specified zone using Telnet service.
Router# configure terminal
Router(config)# ip telnet server rule 11 access-group RD zone LAN action
-> accept
This command displays Telnet settings.
Router# configure terminal
Router(config)# show ip telnet server status
active
port
service control:
No. Zone
========================================================================
Router(config)#

34.7 Configuring FTP

You can upload and download the ZyWALL's firmware and configuration files using FTP. To
use this feature, your computer must have an FTP client.

34.7.1 FTP Commands

The following table describes the commands available for FTP. You must use the
command to enter the configuration mode before you can use these commands.
terminal
Table 156 Command Summary: FTP
COMMAND
[no] ip ftp server
[no] ip ftp server cert certificate_name
[no] ip ftp server port <1..65535>
[no] ip ftp server tls-required
ZyWALL (ZLD) CLI Reference Guide
: yes
: 23
Chapter 34 System Remote Management
Address
DESCRIPTION
Allows FTP access to the ZyWALL. The
command disables FTP access to the ZyWALL.
Sets a certificate to be used to identify the
ZyWALL. The command resets the certificate
no
used by the FTP server to the factory default.
Sets the FTP service port number. The
command resets the FTP service port number to
the factory default (21).
Allows FTP access over TLS. The
disables FTP access over TLS.
Action
configure
no
no
no command
263