Scosche STUCKUP UQ3WDV-SP Manual

INCLUDED ELEMENTS

1. Universal Wireless Charging Phone Mount
2. T-Notch Ball Adapter
3. Window/Dash Mount

4. Vent Mount
5. Car Adapter

6. Cable Routing Clips (2)
   7. Cleaning Wipe

DEVICE SETUP

Universal Wireless Charging Phone Mount Overview Window/Dash Mount Assembly

Universal Wireless Charging Phone Mount

1. Side Support Arms
2. Side Support Release Button
3. Wireless Charging Area
4. Bottom Support
5. Bottom Support Release Button
6. T-Notch Opening

Window/Dash Mount Assembly

1. Remove collar from ball-joint socket
2. Place collar over ball end oft-notch / ball adapter, then place ball end in socket
3. Tighten collar onto socket.
4. Place t-notch hitch in opening.
5. Slide up to lock in place.

Removal

6. Press lever to release t-notch.
7. Slide down to remove.

Window/Dash Mount Installation

1. Clean the mounting surface using supplied wipe*
2. Remove protective film from the StickGrip™ suction cup base**.
3. With the lever in the UP position, place the mount on surface** and press lever down to lock in place.

*Supplied cleaning wipe may cause discoloration of certain plastics, vinyls a nd painted surfaces. It is recommended to test in an inconspicuous area first.
**Note: StickGrip suction cup may leave residue or discoloration on some surfaces. It may also leave a ring of residue when mounted to the dash.

4. To renew and reuse StickGrip mounting base, rinse under warm water and allow to air dry.
   

Vent Mount Assembly &Installation

Vent Mount Assembly

Insert t-notch hitch on vent mount into opening on back of mount head (A), and slide upward (B).
Slide vent mount down to remove (C).

Installation

Rotate vent clips on mount (D) to align with vent (E).

Note: Work with many vent designs (F). Not compatible with curved or circular vents (G).

Mount Adjustment

Press the side & bottom support release buttons (A& B) to fully open the Universal Mount.

Place the device in the mount and manually press the side supports inward to secure the device (C).

Note: The bottom support may also be adjusted manually to raise the device in the mount, if needed.

Press the side support release button to remove the device.

Loosen the ball-joint collar on the Window/Dash Mount (D) to adjust mount angle or rotate mount (E).

Note: Vent mount may be rotated only.

Connection & Charging

StuckUp Window/Dash + Vent

Phone:
800-363-4490 x1
805-486-4450 x1

www.scosche.com

Documents / Resources

References

• Scosche Tech Accessories | #1 Mount Brand in US & Canada

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download Scosche STUCKUP UQ3WDV-SP Manual