Setup And Operation; Initial Connection; Device Boot-Up; Device Default Configuration - Pegasus Astro POCKET POWERBOX ADVANCE Gen2 Product Manual

SETUP AND OPERATION

3.1 INITIAL CONNECTION

▪ Plug the external environmental sensor into EXT port (RJ12 port)
▪ Plug the USB3 cable to the controller's USB port and to your computer
▪ Plug the power supply (battery or power pack) into the "12V DC IN" socket. We strongly
advise using our certified power supply that provides DC 12V / 10 Amps. SKU: PEG-PSU-21

3.2 DEVICE BOOT-UP

▪ The device will boot after three seconds and the LED will turn solid red. This means that the
firmware was loaded successfully and the controller is now fully operational.

3.3 DEVICE DEFAULT CONFIGURATION

▪ Default factory settings are set to standalone mode which means:
a. DC pass through voltage to all four outputs (All outputs are ON and deliver power)
b. Dew Heater outputs are configured to Auto-dew
c. Adjustable Output is enabled and configured to 3 Volts

3.4 SOFTWARE INSTALLATION

▪ To establish seamless communication with the device, please visit our official website at
https://pegasusastro.com. Download the Unity software package, which includes all
requisite ASCOM drivers, to facilitate connectivity with the PPB Adv Gen2.
Click here to download Unity Platform:
Pocket Powerbox Advance Gen2
https://pegasusastro.com/download/
Page 8 of 23
Pegasus Astro – Pocket Powerbox Advance Gen2