Senco Senclamp SC1XP - Stapler Manual

Table of Contents

Tool Use

	Read and understand "SAFETY INSTRUCTIONS" manual shipped with this tool before using tool.
	Keep tool pointed away from yourself and others and connect air to tool.
	To Load: Slide adjuster to correct fastener length. Pull latch and slide magazine rail to rear.
	Place strip of fasteners into magazine with printed side facing out and arrows pointed toward front of tool. Slide magazine rail closed.
	Should a staple jam occur, disconnect air supply.
	Pull latch and slide magazine rail open.
	Remove jammed fastener.
	Connect air supply and replace fasteners.

Read and understand "SAFETY INSTRUCTIONS" manual shipped with this tool before using tool.
All screws should be kept tight. Loose screws result in unsafe operation and parts breakage.
With tool disconnected, make daily inspection to assure free movement of safety element and trigger. Do not use tool if safety element or trigger sticks or binds.
Squirt Senco pneumatic oil (5 to 10 drops) into the air inlet twice daily. (Depending on frequency of tool use.) Other oils may damage O-rings and other tool parts.
Wipe tool clean daily and inspect for wear. Use non-flammable cleaning solutions only if necessary – DO NOT SOAK.

Such solutions may damage O-rings and other tool parts.

Repairs other than those described here should be performed only by trained, qualified personnel. Contact SENCO for information at 1-800-543-4596.

Read and understand "SAFETY INSTRUCTIONS" manual shipped with this tool before using tool.

A = Kit #YK0370

SYMPTOM	SOLUTION
Air leak near top of tool/Sluggish operation	Verify air supply/tighten screws or install Parts Kit YK0370.
Air leak near bottom of tool/Poor return.	Clean tool/tighten screws or install Parts Kit YK0370.
Other problems.	Contact SENCO.

SENCO offers a full line of accessories for your SENCO tools, including:

For more information or a complete illustrated catalogue of SENCO accessories, ask your representative for #MK336.

Minimum to maximum operating pressure	80-110 psi	5,5-7,5 bar
Air Consumption (60 cycles per minute)	3.79 scfm	107.3 liter
Air Inlet	3/8 in. NPT	3/8 in NPT
Maximum Speed (cycles per second)	–	–
Weight	6.3 lbs.	2,8 kg
Staple Capacity	120	120
Tool size: Height	9 ¹³/₁₆ in.	249 mm
Tool size: Length	12 ¹¹/₁₆ in.	322 mm
Tool size: Width: Main Body	3 ³/₁₆ in.	81 mm
Tool size: Width: Rear Bracket	–	–