HP Alletra 4120 Setup And Installation Manual page 17

Unbox the storage server Unbox the storage server
1. Unbox the storage server and verify the contents:
A server
A power cord
Rack-mounting hardware
Documentation
2. (Optional) Install hardware options.
For installation instructions, see "Hardware options installation."
Rack the storage server Rack the storage server
3. Install the storage server in a rack.
WARNING: This storage server is heavy. To reduce the risk of personal injury or damage to the equipment: WARNING:
Observe local occupational health and safety requirements and guidelines for manual material handling.
Get help to lift and stabilize the product during installation or removal, especially when the product is not fastened
to the rails. Hewlett Packard Enterprise recommends that a minimum of two people are required for all rack storage
server installations. A third person may be required to help align the storage server if the storage server is installed
higher than chest level.
Use caution when installing the storage server in or removing the storage server from the rack; it is unstable when
not fastened to the rails.
The racking procedures are included with the rack rails.
a. Connect devices, cables, and cords to the storage server.
4. Decide how to manage the storage server:
Locally: use a KVM switch or a connect a keyboard, monitor, and mouse.
Remotely: connect to the iLO web interface and run a remote console:
a. Verify the following:
iLO is licensed to use the remote console feature.
If iLO is not licensed, visit http://www.hpe.com/info/ilo
The iLO management port is connected to a secure network.
b. Using a browser, navigate to the iLO web interface, and then log in.
https://<iLO hostname or IP address>
Note the following:
The hostname is located on the serial pull tab.
If a DHCP server assigns the IP address, the IP address appears on the boot screen.
If a static IP address is assigned, use that IP address.
The default login credentials are located on the serial label pull tab.
c. In the side navigation, click the Remote Console & Media link, and then launch a remote console.
Power on the storage server Power on the storage server
5. Press the Power On/Standby button.
For remote management, use the iLO virtual power button.
Update the firmware Update the firmware
6. Using the SPP, update the following:
http://www.hpe.com/info/ilo
HPE Alletra Storage Server 4120 Setup and Installation Guide 17