Advertisement
Quick Links
Advertisement
Related Manuals for Woodland Mills Woodlander PRO Log Support
Summary of Contents for Woodland Mills Woodlander PRO Log Support
- Page 1 SAWMILL ACCESSORY PRO LOG SUPPORT...
-
Page 3: General Safety Rules
GENERAL SAFETY RULES WARNING! Remove all log supports and store in a safe location when using a Woodland Mills Sawmill Trailer for travel. Failure to do so could result in loss of parts. COMPATIBILITY The PRO Log Support is designed to work with the following sawmill models:... -
Page 4: Hardware Removal
PRO Log Support HM Series Sawmills 1. HARDWARE REMOVAL Remove the hardware from the log support sleeve on the log bunk where the PRO Log Support Holder will be installed. 2. LOG SUPPORT HOLDER Install the PRO Log Support Holder using the hardware listed below. M10 X 25 mm PRO Log Flanged Hex... - Page 5 PRO Log Support HM Series Sawmills Log Loading Winch If a Log Loading Winch was purchased, do not install the PRO Log Support in this location. Top Hole Bottom Hole [HM122] Bottom Hole [HM126/130(MAX)] 0007339-M-EN: Rev A Page 06-Jun-2023...
- Page 6 PRO Log Support HM Series Sawmills 3. LOG SUPPORT Assemble the PRO Log Support using the hardware listed below. Log Support M14 Lock Nut Handle Log Support Log Support Tube Roller Ensure the handle faces away from the log. 0007339-M-EN: Rev A Page 06-Jun-2023...
- Page 7 PRO Log Support HM Series Sawmills Insert the PRO Log Support into the PRO Log Support Holder. If the PRO Log Support feels too loose in the PRO Log Support Holder, tighten the M10 set screw and thin jam nut. Jam Nut Set Screw 0007339-M-EN: Rev A...
- Page 8 PRO Log Support HM Series Sawmills BUSHLANDER SAWMILL ONLY If the PRO Log Support is being used at the Reverse Bunk location on a Bushlander, the Reverse Bunk will be removed and replaced with the original Log Bunk that came with the sawmill itself.
- Page 9 PRO Log Support HM Series Sawmills Measure 216 mm (8 ½ in) from the face of the End Beam to the face of the Log Bunk. Using the Log Bunk, mark the locations and drill 12 mm (½ inch) holes through the Track Rail for the new Log Bunk position.
-
Page 10: Operation
PRO Log Support HM Series Sawmills OPERATION Insert the Log Support Assembly into the Log Support Holder. Ensure the selected Indexing Hole fits securely on the Locking Pin as shown below. The Log Support Assembly can be raised or lowered by angling the Log Support away from the Angled Pin so it can move freely up or down. -
Page 11: Exploded Assembly View
PRO Log Support HM Series Sawmills EXPLODED ASSEMBLY VIEW PARTS LIST Item Part No. Description 0007342 PRO LOG SUPPORT HOLDER 0006061 PRO LOG SUPPORT TUBE, 475 mm LG 0006062 LOG SUPPORT ROLLER, 20.3 ID X 40 OD X 30 mm LG 0006063 LOG SUPPORT HANDLE 0009487... - Page 12 PRO Log Support HM Series Sawmills NOTES 0007339-M-EN: Rev A Page 06-Jun-2023...
- Page 13 PRO Log Support HM Series Sawmills NOTES 0007339-M-EN: Rev A Page 06-Jun-2023...
- Page 14 PRO Log Support HM Series Sawmills NOTES 0007339-M-EN: Rev A Page 06-Jun-2023...
Need help?
Do you have a question about the Woodlander PRO Log Support and is the answer not in the manual?
Questions and answers