Installing The Wireless Multiport Module - Compaq Evo N620c Series Hardware Manual

Hardware Setup

Installing the Wireless MultiPort Module

Follow these steps to install the wireless MultiPort module.
1. Turn off the computer.
2. Remove the Phillips screw securing the wireless MultiPort
cover on the computer display 1.
3. Remove the wireless MultiPort cover by sliding it toward the
front of the computer 2 and then sliding it to the right 3.
Removing MultiPort Cover
✎
The wireless MultiPort cover should be stored then reinstalled on
the display if the wireless MultiPort module is removed at a later
date.
4. Place the wireless MultiPort module in the MultiPort bay,
making sure to rest the tabs 1 on the back of the module
against the rear edge of the MultiPort bay.
5. Press down on the left rear corner of the wireless MultiPort
module 2, and slide the module toward the back of the
notebook 3 until the connectors are seated.
2–6 Hardware Guide