iQOS bonds S1.5 User Manual page 29

Compatible Power Adaptor Information:
Model: S52A21, S21A20, S21A22, S21A23, S21A25, S21A27, S00120, S00121,
S00122, S00123, S00125, S00126, S00129
Input: 100 V - 240 V ~ 50 - 60 Hz 0.3 A
Output: 5.0 V 2.0 A
Use with supplied Charging Cable
INFORMATION FOR DISPOSING OF BONDS by IQOS
Valid across European Union and EEA
This symbol on the product or on its packaging indicates that
this product and its individual parts (including batteries) must
not be disposed of with your other household waste. Instead, it
is your responsibility to dispose of your waste equipment by
bringing it to a designated collection point for the recycling of waste
electrical and electronic equipment. In addition, waste batteries can be
returned free of charge at the point of sale. The separate collection
and recycling of your waste equipment (including batteries) at the time
of disposal will help to conserve natural resources and ensure that it is
recycled in a manner that protects human health and the environment.
Disposing of waste equipment as unsorted municipal waste (e.g. by
waste incineration or land filling) can have negative effects on the
environment and human health. For more information about where you
can drop off your waste equipment for recycling, please contact your
local city office, your local household waste disposal service or the shop
where you purchased the product. The local importer of the product will
provide for the financing of the treatment and recycling of waste
equipment returned through these designated collection points in
accordance with local requirements.
BATTERY REMOVAL INSTRUCTIONS (FOR DISPOSAL
AND RECYCLING)
Batteries must not be removed by the consumer. At end of product
life, only an authorized recycler may safely remove batteries by
following the steps below.
TM
Discover a world of Services & Privileges with
BONDS by IQOS
For the online version of this user guide, customer care and
extended support services for BONDS by IQOS users,
visit www.iqos.com
BONDS by IQOS (M0031):
TM
Step 1: The device should be fully discharged before disassembling it.
Step 2: Remove the slider cover, screws, foot pad, and foot pad screws.
Step 3: Use an air blower to heat the device cases at the upper and
bottom case gaps, and pull them out. (320°C+/-10C for 20~30 sec).
Step 4: Take out the top and bottom brackets with the heater module
and battery parts.
Step 5: Remove the graphene paper and screws at the brackets.
Step 6: Remove the brackets.
Step 7: Take the bottom side out of the battery, unplugging the battery
connector with tweezers.
Step 8: Take the whole battery out.
Designed and manufactured under the authority of Philip Morris
Products S.A., Quai Jeanrenaud 3, 2000 Neuchâtel, Switzerland.
© 2023 Copyright Philip Morris Products S.A.
TM