Calibration Program; Computer Hardware Requirements; Software Requirements - Tektronix KEITHLEY 2182 Service Manual

In this section:
Introduction ...............................................................................8-1

Computer hardware requirements ............................................8-1

Software requirements ..............................................................8-1

Calibration equipment ...............................................................8-2
General program instructions ....................................................8-2

Calibration program ..................................................................8-3

Introduction
This section provides a calibration program written in BASIC to help you to field calibrate the 2182A.
Refer to Calibration
Refer to Calibration reference
Computer hardware requirements
The following computer hardware is required to run the calibration programs:
•
IBM PC compatible computer.
•
Keithley KPC-488.2, KPS-488.2, or KPC-488.2AT, or CEC PC-488 IEEE-488 interface for the
computer.
•
Two shielded IEEE-488 connecting cables (Keithley Model 7007).
Software requirements
To use the calibration programs, you need the following computer software:
•
Microsoft QBasic (supplied with MS-DOS 5.0 or later).
•
MS-DOS version 5.0 or later.
•
HP-style Universal Language Driver, CECHP.EXE (supplied with Keithley and CEC interface
cards listed above).
(on page 3-1) for details on calibration procedures, equipment, and connections.
(on page 7-1) for descriptions of the calibration commands.
Section 8
Calibration program