Cisco ASR1002 - ASR 1002 Router Quick Start Manual page 22

Table 3 provides information about the LEDs on the Cisco ASR 1002-F Router faceplate.
Table 3 Cisco ASR 1002-F Router LED Activity
LED Label LED
PWR Power
STAT System status
MIN Minor
MAJ Major
CRIT Critical
**Built-in 4xGE 4 LEDs total, one for each
SPA SFP Port SFP
Status
**For more information about the small form-factor pluggable (SFP) transceiver modules that are compatible with Cisco ASR 1002 Built-in Gigabit
Ethernet Ports (4x1GE), refer to the Modular Optics Compatibility section in the
SPA Hardware Installation Guide.
Table 4 provides information about the Cisco ASR1002-ESP-F LEDs in the Cisco ASR 1002-F Router as the system starts.
Table 4 Cisco ASR1002-ESP-F LED Activity
LED Label LED
PWR Power
STAT Status
ACTV Active
STBY Standby
During the boot process, observe the system LEDs. The STATUS LED comes on immediately as amber, then turns to green when
the Cisco IOS is booted.
The system boots differently depending on the configuration that ships with your system. The display below is a
Note
snapshot of messages that are output on the console of the Cisco ASR 1002-F Router system after power-up and during
IOS booting. This is only an example of what you might see from any Cisco ASR 1000 Series Router.
Observe the initialization process. When the system boot is complete (a few seconds), the Cisco ASR 1002-F integrated
Step 4
route processor begins to initialize. The console screen displays a script and system banner.
ASR 1002-F-16-rp0-rommon 2 >boot
bootflash:asr1000rp1-advipservicesk9.v122_33_xn_asr_rls0_throttle_20080114_045627.bin
Located asr1000rp1-advipservicesk9.v122_33_xn_asr_rls0_throttle_20080114_045627.bin
Image size 218869964 inode num 18, bks cnt 53436 blk size 8*512
#########################################################################################################
##############
22
Color Behavior Description
Solid green All power requirements are within specification.
Off The router is in standby mode.
Solid green Cisco IOS has successfully booted.
Yellow BOOT ROM has successfully loaded.
Red System failure.
Amber Minor alarm indicator.
Solid red Major alarm indicator.
Solid red Critical alarm indicator. On at power up
Off Port is not enabled.
Amber Port enabled. Problem with the Ethernet link.
Green Port enabled and the Ethernet link is valid.
Color Behavior Description
Solid green All power supplies are within operational limits.
Off The router is in standby mode.
Green Code has successfully downloaded and is operational.
Yellow BOOT ROM has successfully loaded.
Red Not booted.
Green The integrated services processor is green when active.
None Always be off.
Cisco ASR 1000 Series Aggregation Services Routers SIP and