Front And Rear Panels; E E Tapenstosaceaaate - Roland DIF-AT Owner's Manual

Front Panel
Roland DIF -AT -odZSarASSER,
ADAT TASCAM POWER
E [e] Oo
1 2 3
1 ADAT Indicator
This lights up when an Alesis ADAT and an
RMDB2-compatible device are connected and
both devices are powered up.
2 TASCAM Indicator
This lights up when a TASCAM DA-98, DA-88, or
DA-38 and an RMDB2-compatible device are
connected and both devices are powered up.
3 Power Indicator
This lights to show that power is being supplied to
the DIF-AT.
Rear Panel
6 7
Front and Rear Panels
4 TASCAM SYNC Connector
This sends and receives control commands
between the DIF-AT and a DA-98/88/38. Use the
special sync cable for the DA-98/88/38.
5 TASCAM TDIF-1 Connector
This performs input and output for digital audio
signals on eight channels between the DIF-AT and
a DA-98/88/38. Use the special dubbing cable for
the DA-98/88/38.
6 ADAT Digital In/Out Connector (Optical)
This performs input and output for digital audio
signals on eight channels between the DIF-AT and
an ADAT. Use the special optical cable for the
ADAT.
7 ADAT SYNC Connector
This sends and receives control commands and
synchronization signals between the DIF-AT and
an ADAT. Use the special sync cable for the
ADAT.
8 RMDB2 Connector
This sends and receives control commands and
synchronization signals and performs input and
output for digital audio signals on eight channels
between the DIF-AT and an RMDB2-compatible
device (Roland VM-3100Pro, VM-7100, VM-7200;
etc.). The DIF-AT also receives power through this
connector.
yore
To connect the RMDB2 connectors, you must use the
cable attached to the DIF-AT,or cables which conform
to the RMDB2 standard. Other cables such as for SCS]
connection may damage the products.