Harbour HBRKBC185X Quick Start Manual page 2

Tips & Tricks for using
your new Kegerator
Q U I C K S T A R T G U I D E : H B R K B C 1 8 5 X
Installation & Setup
Before installing your new Kegerator, please read
all safety instructions in the user manual.
Packaging materials: This product has been
packaged to protect it against transportation
damage. Remove all packaging materials from
around and inside the appliance and keep the
original packaging carton and materials in a safe
place. It will help prevent any damage if the product
needs to be transported in the future, and you can
use it to store the appliance when it is not in use.
In the event that the carton is to be disposed of,
please recycle all packaging materials where
possible. Plastic wrapping can be a suffocation
hazard for babies and young children, so ensure
all packaging materials are out of their reach and
disposed of safely.
Clearances: Ensure that air can circulate freely
around the back of the Kegerator which is necessary
to cool the compressor and condenser. Allow at
least 70 mm clear space at the back of the unit and
70 mm at the sides. Also ensure it is placed at least
500 mm from heat sources and at least 50 mm from
electric ovens.
This appliance is designed to be freestanding only
and should not be recessed or built in.
Setting up your Kegerator
You can find a helpful video guide on the installation
process on our website- located at:
https://www.harbour-appliances.com.au/kegerator/
Support: 1300 11 43 57
Operating the Kegerator
IMPORTANT! Before starting, ensure that your keg
coupler is disengaged, and the keg has not been
tapped/opened.
1. Ensure that your kegerator appliance has
been powered on and set to your preferred
temperature for at least 24 hours, with your keg
inside (recommended 1ºC to 3ºC).
2. Open your Carbon Dioxide cylinder/tank using its
valve/knob, to its fully opened position.
3. Before tapping/opening the keg using the coupler,
ensure that your CO2 PSI level is set to the correct
setting (ideally start lower).
4. Tap/Open your keg by squeezing (or pulling)
the couplers handle and pushing it downwards.
You should see a small amount of beer enter
the beer line.
5. Pull the handle on your draft beer faucet/tap to
allow the beer to flow through the beer line, out
the faucet/tap and into your jug or glass.
6. Adjust your CO2 regulator and kegerator
temperature, as required to suit your beverage
and taste.
W W W. H A R B O U R-A P P L I A N C E S .C O M . AU
Version: 1.1