Dakota Digital LED Tail Lights for 1959 Chevrolet Impala, Bel Air, Biscayne LAT-NR241 Installation Instructions

Led tail lights for 1959 chevrolet impala, bel air, biscayne

MAN# 650212

Kit Includes:

Installation:

1. Remove the original bulb sockets.

2. Remove the tail light housing hardware so the housing can be removed from the car.

3. Remove the chrome trim from the tail light housing. The outer trim is snapped into place and

will need to be gently pried off with a flat blade screwdriver or similar tool.

4. Next remove the lens to gain access to the housing. There are ten (10) screws that hold the

lens in place, remove the screws and separate the lens carefully.

5. Now is a good time to clean or replace the lens and housings if necessary.

INSTALLATION INSTRUCTIONS

LAT-NR241

LED Tail Lights for 1959 Chevrolet Impala, Bel Air, Biscayne.

MANUAL 650212

Table of Contents

Do you have a question about the LED Tail Lights for 1959 Chevrolet Impala, Bel Air, Biscayne LAT-NR241 and is the answer not in the manual?

Page 1 MAN# 650212 Kit Includes: Installation: 1. Remove the original bulb sockets. 2. Remove the tail light housing hardware so the housing can be removed from the car. 3. Remove the chrome trim from the tail light housing. The outer trim is snapped into place and will need to be gently pried off with a flat blade screwdriver or similar tool.
Page 2 6. Remove the round mounting plate from the bottom of the LED assembly. It is attached with two lock nuts. Note that there are 4 different assemblies. The left and right side sets are mirrored. 7. Pass the wires through the housing where the original bulb and socket were. Set the LED assemblies into the housing so the two studs extend out the hole in the bottom of the housing.
Page 3: Service And Repair
This Warranty is in lieu of all other expressed warranties or liabilities. Any implied warranties, including any implied warranty of merchantability, shall be limited to the duration of this written warranty. No person or representative is authorized to assume, for Dakota Digital, any liability other than expressed herein in connection with the sale of this product.