Table of Contents
Advertisement
3 Apply light pressure to ensure that it is firmly attached.
To remove the Clip-On:
1 Pull the device down and away from the phone.
2 Lift the device's hook out of the slot on the back of the
phone.
NOTE
If you are using vibration mode with an analog phone,
vibration mode will be turned off when you connect the
Clip-On with your phone.
Installing new batteries
The Clip-On is powered by two CR2430, 3-volt batteries,
which can last for up to nine months of average use.
NOTE
If you see a message, "Battery is low," it is important to
replace the batteries promptly.
To remove the old batteries and install new batteries:
1 Turn over the Clip-On.
2 Slide the door open.
3 Insert a new battery, with the positive (+) side facing the
front of the Clip-On.
4 Carefully close the battery compartment door until it snaps
shut.
32
Chapter 3
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the STARTAC CLIPON and is the answer not in the manual?
Questions and answers