Advertisement
Quick Links
Advertisement
Related Manuals for Vanair Goodall START-ALL JUMP-PACK 12/14V
Summary of Contents for Vanair Goodall START-ALL JUMP-PACK 12/14V
- Page 1 Smart Lithium-Ion Jump Starter and Power Bank USER MANUAL...
- Page 2 Every effort has been made to ensure accuracy. • Carrying Case Vanair Manufacturing, Inc. reserves the right to make design change • Operation Manual modifications or improvements without prior notification. • High Quality 3-way USB Adapter Connector (Lighting, USB-C,...
-
Page 3: Safety Information
Discontinue use immediately and contact Vanair ® NOTE: Unit should be moved IMMEDIATELY to a safe location away DO NOT attempt to charge the Start•All... - Page 4 Pacemaker. DO NOT attempt to alter, modify, or repair any part of the product. Disassembling the product may cause injury, death, or damage to property and voids warranty. Contact Vanair in these instances. ®...
- Page 5 Personal Precaution. Only use the product as battery explosion, follow all safety information instructions and those published by the battery manufacturer and manufacturer of any intended. Someone should be within the range of equipment intended to be used in the vicinity of the battery. Review your voice or close enough to come to your aid cautionary markings on these products.
- Page 6 The Start•All Jump•Pack is supplied with a 2 Amp 18V DC ® online at https://vanair.com/support/registration.html and 100-240V AC wall charger. Make sure the charging cable is securely customer must be able to provide a dated proof of purchase to plugged into the Start•All Jump•Pack...
- Page 7 Store and operate the product in dry locations. Do not operate the product if it becomes wet. If the product Accessories. This product is only approved for use with Vanair ® is already operating and becomes wet, disconnect it from the battery accessories.
- Page 8 Vanair However, there is no guarantee that interference will not occur ®...
-
Page 9: Important Notes
Do not crank dead vehicle for more than 15 seconds. The Start•All Jump•Pack is best used as an instantaneous vehicle ® Wait 90 seconds in between cranking attempts. starting device. Allowing the Jump pack to sit for long durations of time Failure to do so risks damage to the starter, related connected to a vehicles under charged battery will greatly reduce the components and/or the Start•All Jump•Pack... -
Page 10: Charging Accessories
or even operating a bulldozer, the Start•All Jump•Pack® has you Charging accessories covered. The Start•All Jump•Pack is equipped with a 2 Amp 18V DC 100- ® 240V AC Power Wall Charger and a 12V DC port charger for optimal Electronics charging charging convenience at home, work or on the road. -
Page 11: Technical Specifications
Technical Specifications Battery Type: Lithium-Ion Cobalt Capacity: 296 Watt-Hours (296,000 mWh) Peak Current: 10,000A (<200ms) Estimated Lifetime Jump Starts: Up to 5000 Starts Operating Temperature: -4°F to +140°F (-20°C to +60°C) Storage Temperature: 40° F to 75° F (4° C to 24° C) Input Charging Port: 5.5mm - 18VDC 2A Clamp Output Voltage: 12-16V DC and 24/32V DC Output Ports:... -
Page 12: Control Panel
LED Display DC12V ON/OFF USB ON/OFF Main ON/OFF - Function Selector Knob 12VDC Aux Port - 4A 5.5mm - 18VDC 2A USB Type “C” port (4) USB - 5VDC 2.1A, QC 3.0 12VDC 5.5mm Ports - 4A CONTROL PANEL in use. If there is a connection error, a red E followed by a number will be shown - refer to troubleshooting section for •... -
Page 13: Back Of Unit
BACK OF UNIT Emergency Light ON/OFF Button Emergency Light Start•All Jump•Pack // 10,000A • 166500 joules • 12V / 24V ®... - Page 14 A) Status D) Accessory Mode E) DC 12V Ports Activated B) State of Charge C) Charging F) 24V Mode H) USB Ports Activated I) USB-C port G) 12V Mode in Use USER MANUAL...
- Page 15 DISPLAY (Light Emitting Diode) Displays the Start•All Jump•Pack ’s percentage charge or error codes. ® The “%” indicates that the number in the Status is the percentage of power remaining in the Start-All Jump Pack ® The “IN” indicator flashes whenever the unit is being charged by the USB-C port charger, 18V DC 120-240V AC wall charger, or the 12V DC Aux.
- Page 16 ERROR CODE INDICATORS Low Battery Voltage Low Current Low Battery Voltage protection Activated. If the Start•All Jump•Pack ® Low current protection activated. Turn off the Start•All Jump•Pack ® is below 35% when turned on and connected to a vehicle, fully Check the clamp connection on the battery, make sure it is clean recharge the unit then try again.
-
Page 17: Led Indicators
LED INDICATORS Normal Screen Red flashing “12” Normal ON/OFF screen. The display will show a red Displays the battery charge flashing 12 when the unit is percentage. Zero to 64% will put into 12V mode for several display in red. 65% to 100% seconds, then it will go to will display in green. - Page 18 COMPLETE JUMP STARTING GUIDE Note: LED should be flashing Red and Green “8s” (search for battery mode.) 1. Personal safety & battery preparation B. If your vehicle is equipped with jump posts, connect A. Please use safety glasses when jump starting any the positive Red clamp to the positive jump post.
- Page 19 C. Do not crank dead vehicle for more than 15 seconds. Wait for a battery to connect to. If the amps are too low or the 90 seconds in between cranking attempts. Failure to do so will connection is poor, the unit may not connect. Make sure cause damage to the starter and/or the Start•All Jump•Pack that the connection is clean and put the ignition switch ®...
- Page 20 MANUAL ACTIVATION FOR LOW VOLTAGE BATTERIES CAUTION! POWER THE Start•All Jump•Pack “OFF” BEFORE ® The Start•All Jump-Pack is designed to jump-start 12V DC or DISCONNECTING THE BATTERY CLAMPS. THIS WILL ENSURE ® YOUR SAFETY. REMEMBER BOTH THE SPARK PROOF, AND 24V DC lead-acid battery systems at very low voltage.
-
Page 21: Warranty Statement
Warranty Statement TO BE ELIGIBLE FOR THE LIMITED MANUFACTURER’S WARRANTY, THE CUSTOMER MUST REGISTER THE PRODUCT ONLINE AT https://vanair.com/support/registration.html AND RETAIN PROOF OF PURCHASE RECEIPT. This Limited Warranty is made to the original purchaser and does NOT extend to any other person or entity.”... - Page 22 Vanair does not provide any warranty for any accessories used with this product that are not manufactured by Vanair Manufacturing and approved for use with this product. Vanair will make final determination of defects. No agent, employee, or representative of Vanair has any authority to bind to any affirmation, representation or warranty concerning Vanair products, except as stated herein.
- Page 23 Date of Publication: 09/11/2024 090194-OP_r5 091124 RLC 844-VAN-SERV | vanair.com Vanair’s There...
Need help?
Do you have a question about the Goodall START-ALL JUMP-PACK 12/14V and is the answer not in the manual?
Questions and answers