Snow Peak Fubi TP-720 Instruction Manual page 22

9
Pull the slider or tape in the order of A→B→C shown below to remove the slack at the
top of the inner room.
* Do not pull the tape too hard at this time. Pulling too hard may cause damage to the
Fubi body.
A: Move the slider to
tighten the two S-hooks
(rubber loops) attached to
both ends of the back of
the inner room.
B: Pull the tape on the
S-hook attached to the top
of the back side of the inner
room to tighten it.
Finally, peg down the peg down tape located
10
below the zipper of the indoor side. This peg
down reduces the bottom lift when opening and
closing the door, making it easier to open and
close.
A
C
Slider
C: Adjust the length of the tape and
apply tension to both of the S-hook
tapes attached to the upper part of
the inner room as shown in the
figure.
47
Back side
B
Indoor
side