Help - Stannah 600 Starla Using And Looking After

Help

The following checklist is here to help identify possible faults and what can
be done to overcome them. If the checklist doesn't help you to solve the
problem, contact your stairlift supplier, details on the back page.
Code
-/1
Charging / battery fault.
2
No faults found.
Obstruction detected around the
3
footrest / carriage.
4
Power key is not in correctly or
on/off switch is in the 'off' position.
Seat sensor is not detecting you or
5
downside arm is not lowered.
Immobiliser seatbelt is not on
6
correctly (optional)
Seat is not in its travelling position.
7
Service Engineer required.
9/F
22
LED off - The master power switch is off - see page 9.
LED pulsing - Power key is not in correctly or on/off
switch is in the 'off' position - see page 10
LED on - the stairlift is ready to move.
Why? What should I do?
Check that the wall switch is on.
Check that there has not been a
power cut. If problem persists, call
your Stannah supplier.
Call your Stannah supplier.
Check whether there is anything
obstructing the safety edges. If there is,
the stairlift is still on and can be moved
in the opposite direction to allow you
to remove the obstruction. Y ou can then
continue to go up or down the stairs.
Call your Stannah supplier.
Call your Stannah supplier.
If you have an immobiliser seatbelt fitted
then ensure that it is clicked into place -
see page 14.
Swivel seat back to its travelling
position - see page 6.
Call your Stannah supplier.