DAILIS DLS-XJ130L Instruction Manual page 14

Step 6.Rinse the float sensor inside the Recovery tank with clean water.
Step 7.After draining the Recovery tank, cover the drain cap and reinstall the drain hose in its original
position.
Step 8.Unscrew the dirty water filter
counterclockwise. If it is dirty, use a damp
cloth or brush to gently clean it. Wait until
the filter is dry before reinstalling it in the
machine. Do not use a water gun to
directly rinse the filter.
Step 9.Close the sewage tank cover and ensure that there are no
other foreign objects around, as shown in the following figure.
Step 10.Remove the sewage pipe. When holding the sewage pipe upwards, please open the sewage pipe
cover and slowly place the pipe into the
drain or sink.
Step 11.Rinse the clean water tank with
clean water, then rinse the float sensor at
the back inside of the water tank, and
clean the filter screen at the bottom of the
water tank.
Step 12.Open the clean water tank cover and pour in clean water to clean
the water tank. Wipe the bottom of the cover, first install the water-tight
seal ring for the clean water tank, and then put the cover back on.