RIX RNV-31 Manual page 7

06
POWER SUPPLY
Install the storage battery following the below procedures:
1.Unscrew the battery cap.
2.Insert the AA battery (please pay attention to the polarity marked on the device).
3.Tighten the battery cap.
WARNING
》Please remove the battery if the device is not in use for long periods of time.
》Don't power the device with a modified or damaged battery.
NOTE
The decrease in battery pack capacity under sub-zero temperatures is normal and not a factory defect.
08
07
EXTERNAL BATTERY
COMPARTMENT
Align The Marked Points for Installation
1. Install batteries as shown.
2. Power on the battery compartment before connecting to the whole machine, then connect the
battery compartment and RNV-31 with the cable. Turn on or off the power to the battery box, as shown in
the figure (long press).
NOTE
Please use 3.7V standard 18650 batteries. Incorrect installation can cause short circuits and equipment damage.
Battery Installation Diagram
09