Setup; Platter And Drive Belt Installation; Cartridge Installation, Stylus Exchange - Pro-Ject Audio Systems T2 Super Phono Instructions For Use Manual

Table of Contents

SETUP

Please remove drive belt from accessories box and install it as shown in the following illustration. Put the felt

mat on the top of the platter.

* If you purchased this turntable in a package that included the cartridge, this has already been done for

you.

Install the cartridge into the aluminium headshell, using the appropriate hardware included with your

cartridge. All cartridges with half inch mounting holes can be fitted.

Connect the cartridge as indicated below:

•

White

•

Red

•

Green

•

Blue

For correct cartridge alignment, use the two-point cartridge alignment protractor provided with your T2

Super Phono accessories. If unfamiliar with two-point setup, please refer to your dealer.

A damaged or worn stylus may harm your record collection and should be replaced.

Please remove stylus protection before pulling the stylus from the cartridge and replace for a new one.

Stylus type is exchange for pre-mounted cartridge Sumiko Rainier: Stylus Sumiko Rainier. If in doubt, consult your

local dealer or distributor.

left channel L+

right channel R+

right channel R-

left channel L-

Table of Contents

Do you have a question about the T2 Super Phono and is the answer not in the manual?