Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for IWCS iriComm 4.0
Summary of Contents for IWCS iriComm 4.0
- Page 1 User manual iriComm 4.0 V. 06/23FA...
-
Page 2: Table Of Contents
STRUCTIONS CAREFULLY BEFORE FIRST USE. 6.4 Troubleshoot Page: IF INSTALLED, OPERATED AND MAINTAINED ACCORDING TO THIS MANUAL. Technical Data and Specifications iriComm 4.0 WILL BE A RELIABLE PARTNER FOR MANY YEARS 7.1 Specifications Page: TO COME. THOMAS B SVENNINGSEN CO-FOUNDER OF IWCS... -
Page 3: Introduction
Anyone relying on this information should acquire the most current version e.g. upon request at info@iwcs.eu IWCS is not responsible for the content or accuracy of any translations or reproductions, in the whole or in part, of this manual from any other source. -
Page 4: Safety Warning
1 x IWCS Windmuff Kit 1 x IWCS Bandana • POWER LOSS In the event of a power outage, iriComm 4.0 will turn off and will IWCS automatically restart when power is restored. Power interruptions limited to iriComm 4.0 will not affect other users communication. -
Page 5: Iricomm 4.0 Wireless
4.0 paired with another iriComm 4.0. This gives the possibility for 2 persons to be in Full Duplex Intercom without using an iriSound Audio Mixer. In addition to any of the above mentioned use cases, the iriComm 4.0 can be paired with a mobile phone, allowing the user to answer incoming phone calls. -
Page 6: Pairing
Hold for 3 sec. Strobe Hold for 3 sec. From Off Hold for 3 sec. Porthusvej 7A +45 43 43 26 26 Porthusvej 7A +45 43 43 26 26 3490 Kvistgaard info@iwcs.eu 3490 Kvistgaard info@iwcs.eu Denmark www.iwcs.eu Denmark www.iwcs.eu V. 06/23FA V. 06/23FA... -
Page 7: Factory Reset
Incoming phone call Activate pairing mode on your first iriComm 4.0 device by following the instructions on page 12. Place your second iriComm 4.0 into pairing mode #2 as shown on page 12. Porthusvej 7A +45 43 43 26 26... -
Page 8: Charging
The iriComm 4.0 wireless headset, along with some wired PLUS versions, features an advanced Performing a factory reset on your iriComm 4.0 will completely restore all settings to their origi- battery and charging circuit. The headset is equipped with a LiIon battery that offers an nal factory defaults. -
Page 9: Helmet
4.1 Helmet mount 5.1 Microphone The brackets on the iriComm 4.0 are designed to fit a semi-standard 88 mm size for helmet mounts. For optimal performance place the microphone at a distance of less than 1 cm in front of your This size is commonly used and widely available, making it easy to find suitable helmet mounts that mouth. -
Page 10: Swivel Arms
6.1 Maintenance 5.3 Swivelamrs Do not use chemicals or solvents to clean your iriComm 4.0 headset. Use only a damp cloth, The swivel arms on the headset are designed to be adjusted for a proper fit. It is essential to ad- and cold/lukewarm freshwater and wipe/rinse carefully the visible surfaces on your iriComm just them to ensure a comfortable and secure wearing experience. -
Page 11: Cleaning Disclaimer
If your headset has been fully submerged in water, it’s important to follow these steps to prevent potential defects. Please note that the iriComm 4.0 headset holds an IP67 rating while being worn. This rating indicates that if the headset becomes fully submerged underwater while not being worn, water might penetrate the earcups. - Page 12 Technical Data and Specifications 6.4 Troubleshoot 7.1 Specifications Problem Cause Action iriComm 4.0 wireless Headband Helmet Headset will not start up -Battery level too low -Charge battery (Wireless versions only) Radio Wireless 2,4 GHz Weight 375 g 305 g Headset will not start up...
- Page 13 4.0 is developed, designed and manufactured by IWCS Aps Porthusvej 7A 3470 Kvistgaard Denmark +45 4343 2626 Info@iwcs.eu www.iwcs.eu...
Need help?
Do you have a question about the iriComm 4.0 and is the answer not in the manual?
Questions and answers