Quick Steps For Configuring Udld - Alcatel-Lucent OmniSwitch 6850-48 Network Configuration Manual

Configuring UDLD

Quick Steps for Configuring UDLD

1
To enable the UDLD protocol on a switch, use the
-> udld enable
2
To enable the UDLD protocol on a port, use the
by the slot and port number, and enable. For example:
-> udld port 1/6 enable
3
Configure the operational mode of UDLD by entering udld port, followed by the slot and port
number, mode, and the operational mode. For example:
-> udld port 1/6 mode aggressive
4
Configure the probe-message advertisement timer on port 6 of slot 1 as 17 seconds using the following
command:
-> udld port 1/6 probe-timer 17
Note. Optional. Verify the UDLD global configuration by entering the
command or verify the UDLD configuration on a port by entering the
command. For example:
-> show udld configuration
Global UDLD Status : Disabled
-> show udld configuration port 1/6
Global UDLD Status: enabled
Port UDLD Status: enabled
Port UDLD State: bidirectional
UDLD Op-Mode: normal
Probe Timer (Sec): 20,
Echo-Wait Timer (Sec): 10
To verify the UDLD statistics of a port, use the
-> show udld statistics port 1/42
UDLD Port Statistics
Hello Packet Send
Echo Packet Send
Flush Packet Recvd
UDLD Neighbor Statistics
Neighbor ID Hello Pkts Recv
--------------+--------------------+--------------
1
2
3
4
5
6
OmniSwitch AOS Release 6 Network Configuration Guide
:8,
:8,
:0
Echo Pkts Recv
8 15
8 15
8 21
8 14
8 15
8 20
udld command. For example:
udld port command by entering udld port, followed
show udld configuration
show udld configuration port
show udld statistics port
September 2009
Quick Steps for Configuring UDLD
command. For example:
page 17-3