Rip 1 Message - D-Link DES-3326S User Manual

The COMMAND field specifies an operation according the
following table:
Command
1
2
3
4
5
9
10
11
The field VERSION contains the protocol version number (1 in
this case), and is used by the receiver to verify which version of
RIP the packet was sent from.

RIP 1 Message

RIP is not limited to TCP/IP. Its address format can support
up to 14 octets (when using IP, the remaining 10 octets must
be zeros). Other network protocol suites can be specified in the
Family of Source Network field (IP has a value of 2). This will
determine how the address field is interpreted.
RIP specifies that the IP address 0.0.0.0 denotes a default route.
124
DES-3326S Layer 3 Fast Ethernet Switch User's Guide
Request for partial or full routing information
Response containing network-distance pairs from
sender's routing table
Turn on trace mode (obsolete)
Turn off trace mode (obsolete)
Reserved for Sun Microsystem's internal use
Update Request
Update Response
Update Acknowledgement
Table 5-15. RIP Command Codes
Switch Management and Operating Concepts
Meaning