Shutdown - Morbark BEEVER M15R Manual

Spectators, Children, and Untrained Individuals
• Do not allow children or spectators to operate the machine or play
near the machine during operation
• Before operating the machine ensure all untrained personnel are
clear of the machine and standing at a safe distance. Alert all
persons close to the machine before initiating operation
Refueling
• Turn the engine OFF and allow the machine to cool down before
adding fuel
• Fuel and its vapors are highly flammable and explosive. Do not add
fuel around an open flame, while smoking, or where sparks may
occur
• Do not store the machine with fuel in the tank. Only use approved
fuel containers for storage
• Never transport flammable liquids on the machine
Machine Set Up
• Maintain a safe distance from exposed utility (e.g., gas, water,
phone, and power) lines
• Always set the machine up on flat and stable ground or surface and
insure the machine is level. Do not operate the machine on unstable
or sloped ground
• Do not let the engine idle with the clutch disengaged for 2 to 3
minutes or more. Damage to the clutch pilot bearing will occur
• Place wheel chocks under the tires to prevent unexpected
movement during operation if unattached to tow vehicle
• Only operate the machine in a well lit and ventilated area
76347-281 • 12-08
Handling
• Do not climb, sit, stand, or lay on the machine during operation
• Use caution when working and moving around the machine. Walk
and maintain balance at all times
Moving Parts
• Keep away from all moving parts during operation
• Objects or body parts can become cut or crushed if caught in
moving parts. Never attempt to touch a part that is moving until
the power to the machine is shutdown and the part is completely
stopped. Follow the lockout procedure when performing
maintenance on the machine

Shutdown

• Always remove the ignition key and lock the engine control panel
when there is a pause in operation (see Lockout Procedure)
• Parts of the machine remain hot after shutdown. Allow the
machine to cool down for 15 to 20 minutes before performing
maintenance
• If the machine is attached to a vehicle make sure the hitch is
secure and the safety chains are properly attached
• Unattended or parked machines must have wheel chocks placed
under the tires
• To minimize the risk of fire spreading, park the machine a
minimum of 50 ft. from other equipment
• Clean debris from the machine after every use
Safety • General
3
1.5