Operation; Inserting And Removing The Battery; Switching On And Off; Transport - Parkside PBSA 12 E4 Translation Of The Original Instructions

Operation

Inserting and removing the
battery
WARNING! Risk of injury due to
unintentional start-up. Only insert the re-
chargeable battery into the device once
the device is fully prepared for use.
NOTICE! Risk of damage! An incorrect
battery can damage the device and bat-
tery.
Inserting the battery
1. Push the battery (10) along the guide
into the battery holder in the handle
(8).
You will hear the battery click into
place.
Removing the battery
1. Press and hold the battery release (9)
on the battery (10).
2. Remove the battery from the handle
(8).

Switching on and off

Switching on
1. Select the direction of rotation with the
rotation direction switch (7).
2. Select a gear with the gear selection
switch (6).
3. Select a maximum torque or drilling
with the torque adjustment ring (4).
4. Press and hold the On/off switch (11).
The LED work light (12) illuminates.
Switching off
1. To turn it off, release the on/off switch
(11).
2. Wait until the power tool has stopped
before placing it down.
3. During work breaks: Set the rotation
direction switch (7) to the centre. This
precaution prevents the power tool
from starting unintentionally.
4. Remove the rechargeable battery from
the device if you are leaving the device
unattended or if you have finished
working.

Transport

Information on transporting the device:
• Switch off the device and remove the
rechargeable battery. Make sure that
all moving parts have come to a com-
plete stop.
• Remove the attachment tool.
• Always carry the device by the handle
(8).
Cleaning, maintenance
and storage
WARNING! Risk of injury due to un-
intentional start-up. Protect yourself when
performing maintenance or cleaning work.
Switch off the device and remove the bat-
tery (10).
You should have any repair and mainten-
ance work that is not described in these
instructions carried out by our Service
Centre. Only use original replacement
parts.

Cleaning

WARNING! Electric shock! Never
spray down the device with water.
NOTICE! Risk of damage. Chemical sub-
stances may attack the plastic parts of the
machine. Do not use any cleaning agents
or solvents.
• Keep the ventilation slits, motor housing
and handles of the machine clean. Use
a damp cloth or brush to do this.

Maintenance

The device is maintenance free.
GB IE NI
13